|
| Other Films |
| There are lots of different plastic and
vinyl films out there, but only urethane Paint
Protection Film has been specifically engineered,
along with its special adhesive, to provide the best defence
against stone chips, bugs and road debris, as well as
looking good.
|
| Applications |
The film can be applied onto any painted surface, such as
- Cars and 4x4s
- Motorcycles
- Bicycles
- Truck and buses
- Vending Machines
- Office Equipment
- etc., etc.
|
|
Paint Protection Film has been specifically designed to keep your
vehicle's painted finishes looking great.
This film is used by Ferrari, Mercedes-Benz, Ford, HSV, Toyota,
Mitsubishi, Moto Guzzi, Nissan, Land Rover, BMW, Subaru, Audi, Porsche and
Volkswagen to protect the exterior paintwork on their vehicles.
If it didn't work, if it affected the
paint, if it didn't allow proper fading - would these guys apply it
to their vehicles and risk warranty issues?
|
Once installed, it provides a tough, glossy, crystal-clear, almost invisible protective surface that takes all of the beatings that your paint would
normally take. Therefore you don't have to get your car resprayed to get rid of those hundreds of tiny (and not so tiny) stone chips in
the paint; because the film takes the brunt of the force from stones, bugs and other road debris.
Stones can take the paint back to the metal, allowing rust to set in.
Bird poo and bug's guts can also etch into the painted finish, and can
be difficult to remove.
Incredible as it may seem, the most popular film is only .15mm thick (6 mil
= 6 thousandths of an inch, in the imperial measurements), yet it manages to protect
your painted surface from years of damage and keeps your car looking new.
We install computer cut pieces that have been specifically designed for your car. Therefore
they fit perfectly and provide maximum coverage. Some other operators
apply whole sheets of the film onto the car and then trim it to fit. They could make cuts in your
paintwork thereby damaging it, letting rust form and also cannot guarantee that all of the edges will be consistent or cleanly cut.
Our kits usually have rolled edges on the bonnet to protect the very vulnerable leading edge. Compare our kits with our
competitors' kits before making your decision. We believe that we have the best designed, best coverage kits on the market.
Have a look at the menu on the left to learn more about this wonderful film. |
|
|
| Maintenance |
| The film is pretty good at looking after
itself, but it's wise to take care when washing the car to
always wipe cloths 'from the film to the paintwork'. This
action helps to protect the edges of the film. Also,
the film must be washed at least
once a month. We
recommend that you keep
the film waxed to minimise discolouring from dirty water,
chemicals and bugs. When waxing, you may wish to apply
a strip of masking tape along the film's edge to stop wax
build up along the edge. Remove the masking tape
promptly after waxing. Remove bugs and tar with a Tar and
Bug Remover - let the chemical do its job, and don't rub too
hard. |
|
